High Surface Density Dunlop(FR) 9''1/4x1 S09101 Air Spring Shocks M8 Bolts
Product Details
Bottom Plate Alignment: Parallel
Bottom Plate Center To Center Diameter: 89 mm
Bottom Plate Diameter: 161 mm
Bottom Plate Hole Quantity: 2
Bottom Plate Type: Steel |
Top Plate Alignment: Parallel
Top Plate Center To Center Diameter: 89 mm
Top Plate Diameter: 161 mm
Top Plate Hole Quantity: 2
Top Plate Type: Steel |
Bellow Maximum Diameter: 250 mm
Expanded Height: 140 mm
Compressed Height: 51 mm
Spring Type: Single Convoluted
Nut/Blind Nuts Type: 2×M8 |
| Air Inlet: G1/4 |
Part Number
Dunlop(FR): 9'' 1/4x1 S09101, 9' 1/4x1 S09101, 9 1/4x1 S09101
Contitech: FS 200-10, FS 20010, FS 200 10, FS200-10, FS20010, FS200 10
Firestone: W01-M58-6374, W01 M58 6374, W01M586374, WO1-M58-6374, WO1 M58 6374, WO1M586374
Phoenix: SP 1B 12, SP1B12
Bosch: 822419004
Festo: EB-250-85
Norgren: PM/31091(81/4x1), PM31091(81/4x1), PM 31091(81/4x1)
Dunlop Other Types of Air Suspensions
| SP2906 | SP2907 | SP2910 |
| SP2334 | SP2441 | SP2895 |
| SP2913 | SP2917 | SP2923 |
| SP1536 | SP1482 | SP2861 |
| SP1537 | SP1490 | SP2863 |
| SP2523 | SP1538 | SP1539 |
| SP1540 | SP1541 | SP1542 |
| SP1543 | SP2782NB | SP1558 |
| | SP1556 | SP2141 |
| | SP1557 | |
| | SP1408 | |
| | SP2342 | |
Assembly Method of Air Spring
(1) The insertion of lumbar ring
The air spring is pressed inward by hand, and the ring is inserted in turn. After the ring is inserted into the fixed position, the air spring under pressure is pulled out to restore its original state. When there are 4 or more flaps, rings can be mounted from both sides according to this method.
(2) the installation method of upper and lower plates
The upper and lower plates and the air spring are gently inserted, and after height restriction, compressed air is gradually sent in to improve the internal pressure. The upper and lower plates can be automatically inserted with the air spring to achieve sufficient airtightness. If internal pressure is applied at unrestricted height, the upper and lower plates will collapse out. Therefore, it is important to pressurize the upper and lower plates in a device of sufficient strength to limit height. Air spring and upper and lower plate sealing parts, such as foreign bodies, rust, oil and other phenomena, should be cleaned up before operation. In addition, the rubber and the upper and lower board of the joint part of some soap and water, will be more easy to chimeric.
1B200-10 Detailed Pictures
